Installation Procedures For Siglite Road Marking Reflector - Seih-Ying Co., Ltd.

Home> Products>Installation Procedures For Siglite Road Marking Reflector

Installation Procedures For Siglite Road Marking Reflector

To inquire or purchase, select products on and click

Installation Procedures for Siglite Road Marking Reflector

Installation Procedures for Siglite Road Marking Reflector ((glass road stud, 360 degree Cat Eyes))

1. Road safety Devices. 2. Use drill stop on the drilling bit to drill hole(Diameter:100mm, Depth:25mm) 3. Use hammer and chisel to remove the asphalt or concrete debris in the hole. 4. Use high pressure air blower to...

Installation Procedures For Solar Siglite(A-68)

Installation Procedures For Solar Siglite(A-68)

1. Drill a hole of 42mm depth in the pavement with the 112mm drilling bit.(Use the drill stopper to assure the correct depth of the hole). 2. Use special socket tool to remove the excessive gravels of asphalt from the h...

Installation Procedures For Solar Siglite(A-666)

Installation Procedures For Solar Siglite(A-666)

1. Drill a hole of 30mm depth in the pavement with the 4”drilling bit.(Use the drill stopper to assure the correct depth of the hole). 2. Use special socket tool to remove the excessive gravels of asphalt from the...

Installation Procedures for All-position Tempered Glass Reflective Warning Light(SIG-D50)

Installation Procedures for All-position Tempered Glass Reflective Warning Light(SIG-D50)

1. Made adequate facility of safety warning. 2. Mark on the position to be worked. 3. Drill a hole at diameter of 52mm and depth of 42 mm with drilling machine (mark on the drilling machine or put a ring at the drillin...

To inquire or purchase, select products on and click